Woodstock Trimmer M1040 User Manual

Model M1040 & M1041  
Plate Shear  
Instruction Sheet  
Inventory  
Plate Shear Assembly...........................................1  
Hex Bolts M10-1.5 X 40 (M1040)...............................2  
Hex Bolts M12-1.75 X 40 (M1041)..............................2  
Flat Washers 10mm (M1040)...................................2  
Flat Washers 12mm (M1041)...................................2  
Handle ............................................................1  
Shearing Dimensions (Mild Steel)  
Maximum Shear Thickness..................... 7 gauge (316")  
Maximum Rod Diameter (Rebar/All Thread) ............. 12  
"
Note: DO NOT attempt to shear hardened or stainless  
steel. You will damage or break your shear blades!  
Assembly and Mounting  
To assemble and mount your shear, do these steps:  
1. Secure the handle to the plate shear assembly using  
the included hex bolts and flat washers, as shown in  
the parts diagram on the next page.  
M1040  
8" Shear  
M1041  
12" Shear  
2. Place the shear on the workbench, and use the holes  
in the base as a guide for drilling and attaching the  
shear to the workbench.  
Figure 1. Model M1040 and M1041 Plate  
Shears.  
3. We recommend using through bolts (hex bolts that  
go through the workbench and are secured from the  
other side with flat washers and hex nuts) if possi-  
ble. If it is not possible to use through bolts, use lag  
screws with flat washers and fasten the lag screws  
directly into the workbench.  
The shear blades are very sharp! Keep  
body parts away from the cutting  
area, or serious injury may result!  
Note: If the material seems too thick  
or too hard, do not force the shear!  
Instead, use a metal-cutting bandsaw  
to cut the workpiece.  
Basic Operation  
To perform basic shearing operations, do these steps:  
Maintenance  
1. Raise the threaded stop if needed to allow room for  
the workpiece.  
Always keep blades lubricated with a  
light oil.  
2. Turn the stop so the stop pad if firmly pressing the  
Keep pivot points tight.  
workpiece against the lower blade.  
Check mounting fasteners and all shear  
hardware before every use for loose or  
worn components.  
3. With slow and even pressure, pull the handle down  
to cut the workpiece.  
 

Weed Eater Trimmer 530087645 User Manual
Weslo Treadmill Wetl15131 User Manual
Weslo Treadmill WLTL29321 User Manual
Westinghouse Indoor Furnishings W 128 User Manual
Westinghouse Toaster WTO1010B User Manual
Whirlpool Cooktop G9CE3675XB User Manual
Whirlpool Ventilation Hood UXT4030AAB User Manual
White Lawn Mower 134A676F190 User Manual
Zanussi Food Warmer Cook Plate User Manual
Zebra Technologies Printer Q3DLUBA000002 User Manual