Application Advisory
AA-070610 (XSS VOLUME CONTROL)
XSS24100W, XSS26100W
Model #’s
KEY POINTS:
Setting the Volume – To set up the system, the amplifier/receiver should be at the lowest
volume setting. The XSS speaker selector\volume control should be the highest volume
setting. Slowly adjust the amplifier/receiver to a level that is acceptable before any
clipping or distortion is heard. The clipping and distortion point is where the
amplifier/receiver is at its maximum performance. Any excessive usage beyond this point
will cause the system to be overworked and subject to shutting down.
Mark the Amplifier/Receiver Setting – To be sure the amplifier/receiver volume setting
is not adjusted after installation; use a label maker on the amplifier/receiver to note the
maximum volume setting and that no adjustments should be made.
Figure A: The arrow indicates the maximum volume setting.
Avoid Amplifiers/Receivers with only 8-Ohm Power Rating – Amplifiers that only list 8-
Ohm power ratings are subject to poor performance below 8-Ohms. Speakers will not
consistently present impedance at the manufacturer’s specification. It is strongly
suggested to use an amplifier/receiver that is flexible with speaker loads down to 4-
Ohms. Amplifiers/Receivers made in the 80’s and 90’s are typically not the best
performers. The XSS2400W/XSS26100W is compatible with all Xantech amplifiers
except the PA4100X.
Do not use Bridge-type Amplifiers (including internally bridged amplifiers) - The XSS
Speaker Selector\Volume Control is not recommended for bridge-type amplifiers. Using
a bridged amplifier with the XSS2400W/XSS26100W may seriously damage the
amplifier and speaker selector. If you are not sure your amplifier is bridged please contact
the manufacturer.
Xantech LLC, 13100 Telfair Avenue, Sylmar, CA 91342
Phone: (818) 362-0353, Fax: (818) 362-9506
Application Advisory, XSS Volume Control © 2010 Xantech LLC
This document is copyright protected. No part of this manual may be copied or reproduced in any form without prior
written consent from Xantech Corporation. Xantech Corporation shall not be liable for operational, technical, or editorial
errors/omissions made in this document.
|